Switching to vertical: First results

cg3000A few months back I switched from a magnetic loop antenna to a vertical one. There were two main reasons to do so. The first one is the ability to be able to remotely tune the antenna. With the I3VHF-loop I wasn’t able to. The second reason was to have support for the 80 (and soon to be released) 60-meter band. If 160 would work this would be a great benefit.
Using a 12-meter high SpiderBeam fiber pole, without the last section, a wire goes 10,5 meters up and 3,5 meters to the side, with a total length of 14 meters. This length is chosen because the wire was already in stock and isn’t resonating on any of the ham bands. The CG-3000 tuner will tune the wire to all bands, including 160-meters. But the topband isn’t really workable with S9 noise.

Last week I made about 200 QSO’s during the CQ-WW-DX SSB-contest to test the antenna. Lower bands in particular perform much, much better with the new set-up comparing to the I3VHF loop. On the 40-meter band, local QSO’s are quite impossible (No more ‘noise’ from 7077 kHz a.k.a. ‘CB channel 14’ in the Netherlands) and distances 1000 miles away are better. I’ve worked D4C in Cape Verde, Kuwait, a US West coast stations, Canada and Barbados in the Caribbean.

Last week I had some time to do tests in JT65 on the 80-meter band. I hoped to get outside of Europe on this band, but did not expect to have QSO’s with the US and Canada (6.000 km) and Australia (18.000 km). The original goal is still set: 100 DXCC on both 160 and 80 (maybe even 60) meters together before the end of this year. To achieve that, I have to run a night during next month’s CQ-WW-DX CW-contest.

4 comments

1 ping

Skip to comment form

  1. Hallo Randy, ik werk zelf ook al jaren met een vertical en een CG3000 tuner. Even een vraag, hoe is de SWR op 10m en 12m met deze lengte van antenne. Zelf gebruik ik een lengte van 7,1m straler en 3×7,5m tegencapaciteit onder een hoek van 45gr. Zie in jou verhaal niks over de tegencapaciteit, wat gebruik je als radialen? 100DXCC op 160 en 80 voor het eind van het jaar zou ik erg knap vinden. Weet niet op hoeveel je staat maar je counter geeft 179 DXCC all band aan. Succes! 73, Bas

    1. Bas,

      Ik gebruik 2x 20 meter en 2x 11 meter aan radialen. Op hogere banden wordt het stralingspatroon inderdaad grilliger. Omdat de voet van de mast op de grond staat geen elevated radials, dus ik kom wat tekort, ook omdat ze enkel terug kunnen in de tuin en dus niet ideaal rond staan.

      De 100 bandpunten zijn voor 160/80 (en eventueel 60) samen. Zeker niet per band. Dat gaat voor eind 2016 niet lukken.

    • Adrian on 30/03/2021 at 12:04
    • Reply

    Hi, Randy,

    What maximum power do you use when working FT8 or JT65 with CG 3000 antenna tuner?

    73 de YO9FMB,
    Adrian

    1. 100 when tuned. A bit less while tuning.

  1. […] availlable. Tough I was operator at PI4AMF I also spend some hours making QSO’s from home. In total 200, […]

Leave a Reply to Bas PE4BAS Cancel reply

Your email address will not be published.