DVB-S with ADALM PLUTO SDR

Peter (PA3PM) started to do some experiments with the ADALM SDR. This type of SDR is available for about $100 and capable of transmitting and receiving – even full-duplex – between 70 MHz and 6 GHz with a bandwidth up to 56 MHz. It’s capable to make DVB-S (and DVB-T) transmissions out of the box.

This week I’ve received my box. Within half an hour I was capable to produce an image on the PI6ATV repeater using the 1265 MHz DVB-S input and an old webcam. This is done with the native 0 dBm (1 milliWatt!) output of the SDR connected to my 120cm dish. I do have to note that there is a line of sight with the Gerbrandy tower more than 30 kilometers away.

Next is to amplify the signal using some RA18H1213G modules (18 Watt FM, 3 Watt DVB) on 23cm or some 3G modules still on stock for 13cm. And… more important, to filter the signals since the SDR will create harmonics.

B5 picture using 0 dBm over 30km+ distance

B5 picture using 0 dBm over 30km+ distance

Technical specs:

  • Separate RX and TX connector
  • 12 bits DAC/ADC
  • USB2 interface
  • 65.1 kSPS to 61.44 MSPS (200 kHz to 20 MHz signal bandwidth)
  • 325 to 4 GHz tuning range (70 MHz to 6 GHz after ‘mod’)
  • Runs Linux with an open design. 2 Second boot time.
  • 32 MB of Flash, 512 Mb of DDR3 memory
  • Only 72 parts on the board, thus cheap
  • Better RF than AD9363 specs
  • Highly linear broadband transmitter
    • Transmit (Tx) error vector magnitude (EVM): −34 dB
    • Tx noise: ≤−157 dBm/Hz noise floor
    • Tx monitor: 66 dB dynamic range with 1 dB accuracy
  • 2.4 Hz local oscillator (LO) step size
  • NO RF Shielding, NO RF Filtering. Use a low-pass filter!
  • Linux IIO interface: USB, Ethernet, Mass storage, Serial, DFU
  • Also capable to act as USB Host device
  • Very easy firmware update. Drag, drop and reboot. (and pray…)

3 comments

2 pings

    • Pe1jb on 05/02/2019 at 14:52
    • Reply

    Waar is de plutoadalm te koop.

    1. https://nl.mouser.com momenteel 129 euro incl. verzending.

    • harry on 23/02/2019 at 12:55
    • Reply

    hallo
    heb een adalm pluto gekregen ze dachten dat ik er blij van zou worden echter het is geen ontvanger die zo aansluit heb op internet gekeken maar dit gaat mijn pet te boven
    is er meschien een site waar ik de basic infomatie kan vinden hoe je deze pluto kan progameren tot een ontvanger

    grt harry meertens

  1. […] maken op 2330 MHz. Ideaal nu DVB-S experimenten voor onder de 100 euro gedaan kunnen worden met de ADALM Pluto SDR tussen 70 MHz en 6 […]

  2. […] Enkele zendamateurs zijn de laatste weken erg actief met de ADALM Pluto SDR. Deze SDR kost nog geen 100 euro en is geschikt om DVB-T en DVB-S(2) te maken. Een computer, wat software en een webcam zijn, naast een antenne voor 23cm of 13cm, voldoende om van start te gaan. En hoewel de SDR slechts 0 dBm (1 milliWatt) vermogen levert, lukt het meerdere amateurs om ruim 30 kilometer te overbruggen richting de digitale ingang van PI6ATV waaronder PA3PM, PE9RX en ikzelf, PH4X. […]

Leave a Reply to harry Cancel reply

Your email address will not be published.